Pre-Use Checklist:

Before turning the device on:

1. Ensure tubing is not kinked or folded inside or outside the sauna. Verify that steam can flow freely from the SmartSteam Unit to the steam dispenser.
2. Secure the lid properly by firmly pressing the lid down into the grooves on top of this steamer and rotating the lid clockwise.
3. Confirm that the water level in the SmartSteam chamber does not exceed the maximum fill line. Overfilling may lead to improper operation or damage.

During Use:

1. DO NOT touch the SmartSteam unit or the steam dispenser during or after use. They contain boiling water and are extremely hot.
2. If your sauna does not heat up within 15 minutes, unplug it to turn off the device immediately. Allow at least 15–20 minutes for the unit to cool down before investigating the issue.
3. If you notice steam escaping from the SmartSteam Unit, Ddo not touch the device. Unplug it and wait at least 15–20 minutes before attempting to inspect or adjust it.
4. While inside the sauna, be cautious of the steam dispenser - It is extremely hot.

Post-Use Reminder:

1. Always double-check tubing for obstructions before each use to ensure safe operation.
2. Always unplug the SmartSteam unit from the wall after use.
3. After use, the SmartSteam unit and the steam output box will be extremely hot.

(09) Next assemble the steam output box (refer to image above):

Attach the LONGER tube to the steam output box. Then, screw the connector into the tent. Attach the tube to the connector.

(10) Assemble the SmartSteam unit: Attach the SHORTER tube to the output hole on the lid. Then, attached the end of the tube to the SaunaBox connector.

[Ensure there are no kinks or folds in the tubing attached to the steamer]

Once fully setup and you are ready to use the SaunaBox, plug the SmartSteam unit into a 110V outlet.

(11) Insert SweatLock Floor Mat: With the logo facing upwards and nearest to the door opening, slide the SweatLock Mat in. it should fit snug on the bottom of the sauna.

(12) Assemble Chair

(13) Lock the lid in place by pushing down and turning it clockwise. It will lock into the grooves.

(14) Fill roughly 4 Liters of distilled or filtered water inside the stainless steel heating chamber.

DO NOT put essential oils into the chamber (Refer to page 20 for essential oil use)

(15) Turn on SmartSteam unit by pressing the on/off button.

(16) Adjust Heat Level: To begin, start at level 1-8 and slowly increase to level 8 or 13. Level 13 should ONLY be used if sweating cannot be achieved on lower levels.

(17) Adjust Duration: We recommend starting at 20-45min. You can adjust the time and heat at any time by pressing the "+" or "" buttons

(18) Make sure the door is fully shut and zippers are closed.

(19) Please allow 10-15 minutes for the SaunaBox to heat up and start producing steam.

(20) Once the inside of the SaunaBox is at vour desired temperature. open the door and sit inside to enjoy endless relaxation and rejuvenation.

Issue: Sauna not heating after 15 minutes

• Solution: Unplug the device to turn it off. DO NOT touch the SmartSteam unit.
• Allow the unit to cool for 15–20 minutes before inspecting.
• Check the following:

1. Tubing is free of kinks or blockages.
2. The water level in the SmartSteam chamber is appropriate.
3. The lid is securely twisted clockwise into place.

Issue: Steam escaping from the SmartSteam Unit

• Solution: Unplug the device to turn it off. DO NOT touch the SmartSteam unit.
• Allow the unit to cool for 15–20 minutes before inspecting.
• Check the following:

1. The lid is securely twisted clockwise into place.
2. Tubing is free of kinks or blockages.

Issue: You hear hissing coming from the SmartSteam unit lid

• Solution: Unplug the device to turn it off. DO NOT touch the SmartSteam unit. Allow the unit to cool for 15–20 minutes before inspecting.
• Check the following:

1. Tubing is free of kinks or blockages both inside and outside the sauna. 
2. The lid is securely twisted clockwise into place.

• DO NOT open the lid of the steam while it is in operation and always allow the steamer to cool before cleaning or touching.

• DO NOT touch the SmartSteam unit or the steam dispenser during or after use. They contain boiling water and are EXTREMELY hot.

• NEVER move the steamer while it contains hot liquids.

• While inside the sauna, be cautious of touching the steam dispenser - It is extremely hot.

• Once you have completed your session, exit the sauna.

• Always unplug the SmartSteam unit from the wall after use.

• For sanitary reasons, we recommend you clean the sauna between each session (Refer to next page for cleaning instructions)

• CAUTION: After use, the SmartSteam unit and the steam output box will be extremely hot.

• Leave the SaunaBox door open to air out completely.

Need more help? Contact our top rated support team and we'll help you out.